![]() Then, from the top edge of the paper measure at both side edges, 13,50 cm. In this pattern, the most important thing is the top part of the hat, where are darts located.Ĭut out from paper piece width 27 cm, length 35 cm.įold over the paper vertical in half so that folded paper is 13,50 cm width. Since both halves of the beanie are identical, it is enough to draw a pattern for only one half, so we just need half the volume, and it is 27 cm. In the table are given recommended ranges, which doesn’t mean that you can’t choose something that isn’t supported if you want a longer or shorter beanie. The beanie’s circumference in the table under Teenager/Adult small/Women is 54 cm, and for a length, you can decide how long your hat would be. ![]() Material required for making the pattern: large format paper or pattern paper (I used three A3 paper), pencil, lining, and geometry compass. For all other sizes, the process of making this pattern is almost identical, the only difference is using of corresponding numbers. The value corresponds to a certain age specified in the table.ĭescription of the process of drawing a pattern corresponding measurements given in the table for Teenager/Adult small/Woman follows below. Circumference and length define each beanie, and below is the table with the circumference and the recommended range for beanies.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |